Hi My RRS 2010 3,6 has developed an adaptive dynamics fault

I have checked the fluid level and that is OK. Do I check the ride height sensors & wires next ? on the 4X4 screen it all shows as normal (no red lights).

Cheers

What's the fault? Do you have fault codes or just an error on the dash? 2012 SDV6 - it's missing a couple of cylinders
2008 TDV8 - it was a labour of love and is much missed

Only message on dash it only happened last night i left it overnight as i wasnt sure if it was heat related but it was there this morning also. will hopefully grab codes later today..

Mine has been doing this intermittently for a while now, sometimes when I switch it off and start it again it disappears. Mine is a rear height sensor code. Thats where I would be looking first  2003 BMW M5 - 5 Litres of V8 Optimax Slurping Goodness in Carbon Black

2013 SDV6 HSE Black Edition- Orkney Grey with Ebony & Ivory. LR Facelift RAI, Genuine G4 Expedition Rack, 4x Warn SBD-160 Spotlights, Warn 9.5XPS Winch, Mantec Underbody Protection and Sump Guard, Full Easy Lift Suspension Module, LR Light Guards, Light Force HTX230 Hybrid spotlights, 18” Compomotive PD1881 on 265/65/18 BF Goodrich KO2, ARB fridge, TuffTrek awning 😎

Hi
Had codes read and it’s rear right ride height sensor. Going to order a new one. Tried to get old one out to check part number but 2small torx head screws are just spinning looks like I will need to be brutal and break sensor apart !!!!!

Cheers

I believe you will need to set up height again if replacing one, thats what i was told  2003 BMW M5 - 5 Litres of V8 Optimax Slurping Goodness in Carbon Black

2013 SDV6 HSE Black Edition- Orkney Grey with Ebony & Ivory. LR Facelift RAI, Genuine G4 Expedition Rack, 4x Warn SBD-160 Spotlights, Warn 9.5XPS Winch, Mantec Underbody Protection and Sump Guard, Full Easy Lift Suspension Module, LR Light Guards, Light Force HTX230 Hybrid spotlights, 18” Compomotive PD1881 on 265/65/18 BF Goodrich KO2, ARB fridge, TuffTrek awning 😎

Yes I know that calibration of suspension height is required filling the change. I cannot understand why the 4x4 screen was showing normal orange mark by ride height ? If sensor or wire is faulty surely it would show as red ?