Morning all,

so i have just bought an IID tool. its great at most things but i dont seem to be able to read any DPF info.

options are there to view live data around inferred soot concentration and remaining DPF volume but the soot concentration show N/A and the remaining volume just sits on 0L.

does anyone know if its possible to monitor the DPF info on a 2010 RRS 3.0L? i have seen plenty of posts with these values shown but not on the 3.0. im keen as i have a pretty re-occurring DPF warning due to the limited travel during lockdown and want to view the figures and monitor that it is burning off properly as it came on again yesterday after a pretty long commute to the office (90mile round trip) altho i think i was cruising a little too fast to allow it to regen (80ish)

Yes. Loads on this on the Full Fat forum...put "DPF" into the search field and take an hour or 2 break
"DPF soot conc - inferred using differential pressure" is the field to monitor for "soot load" in the DPF.
Ignore the remaining volume Visitor from fullfatrr.com
* GONE. 2012 RR Sport HSE SDV6 Orkney Grey. Now being piloted by RRSTDV8
* Current: 2011 4.4 TDV8 Full Fat. Amazing piece of kit.
* Current. 1974 Lightweight 2.25L petrol. Old skool
* GONE. Freelander GS TD4 Manual MY2013. Orkney Grey with privacy, cold and clearview packs, armrests (a must!) and a spoiler.
* GONE. Range Rover Classic '93 200Tdi Factory fit
* 1949 80" in family since 1975

Yea i thought as much but when i look the live data for the soot concentration just says N/A.