Hi all

Juat got my self a RRS 2008 SC and when i lower the suspension it goes in to extended mode and the suspension rises however if i press the button again it stays low but extended msg is shown.

Any ides on what it could be, looing at the 4x4 screen the red dots are level and nothing looks out of place

Thanks

Heights need calibrating or you have a dodgy height sensor. Bodsys Brake Bible
Software Updates Contact me
RRS Timed Heat/Remote kits - Contact me
BAS Engine Re-maps/ EGR Blank EuIII and EuIV
Clock On The Dash/ SNOTM /3Flash / BT Update /Service Reset/Error Codes read\ Gearbox Reset
See it HERE

Hi Bodsy

thank you for responding. do you know anyone who can do this in London apart from a dealer not sure what the cost would be to recalibrate or replace the sensors

could be a clogged up cone filter on the compressor....

Has anybody lowered the suspension using one of the EAS Control lowering tools, as have seen them lowered to far, and are OK in Normal Ride Height, but if Access height is selected car lowers to far and thinks it has bottomed out and Rises to clear Obstacle.

Cheers
Col

Hi All

just to let you know that I took my RR to Aylmer Motorworks to have a look at the issue.

They plugged my car in to the computer and no error codes and all is fine so they got the car up on the ramp and looked at the Height sensors and found that the rear left the connection had some slight corrosion so they cleaned that off and now its working fine.

the best part is this work was paid for by my warranty that came with the car which is Autoguard Warranty.

Regards