Hi all, I have an issue with the drivers window. When I press the switch to open it, it moves 1-2mm but no further; it moves back up to seal again ok too.

The other three windows are all fine and I have performed the window reset in accordance with the manual. Any ideas?

I'm guessing it's not the fuse as the window will move a little bit each way, and the relay is shared by all windows so this is probably fine too.

(MY10 RRS 3.0TDV6)

Thanks! Current: Range Rover Sport 3.0 TDV6 HSE in Stornoway Grey
Previous: Discovery 3 2.7 TDV6 HSE in Zambezi Silver

Aha! Fixed!!

Someone on the Facebook group came up trumps for me. It was the anti-pinch mechanism that needed resetting as the window must have been frozen shut when I last tried to open it. I disconnect the battery -ve terminal for 20 seconds then reconnected. Reset the windows and I now have 4 working windows!!

Thought I'd post the fix here in case anyone else gets it! Current: Range Rover Sport 3.0 TDV6 HSE in Stornoway Grey
Previous: Discovery 3 2.7 TDV6 HSE in Zambezi Silver

Hi,

How did you do the reset?

Close the windows with the switch, release the switch and then pull the switch up for about 3 seconds and release. You need to do this on all four windows, from the drivers door position. Current: Range Rover Sport 3.0 TDV6 HSE in Stornoway Grey
Previous: Discovery 3 2.7 TDV6 HSE in Zambezi Silver

Ovey wrote:

Aha! Fixed!!

Someone on the Facebook group came up trumps for me. It was the anti-pinch mechanism that needed resetting as the window must have been frozen shut when I last tried to open it. I disconnect the battery -ve terminal for 20 seconds then reconnected. Reset the windows and I now have 4 working windows!!

Thought I'd post the fix here in case anyone else gets it!

That worked for me too today thanks. Noticed whilst driving that drivers door window went down 10mm and stopped - could raise it to fully closed though all through the drivers door switch. Reading this thread I remembered a couple of days ago I tried to lower the window but it was frozen so never thought much about it - the reset procedure fixed it straight away