Hello,
I'm sure this has been asked before but i've not been able to find in previous posts..i have a 2012 RRS 3.0 tdv6 Luxury model. It does not have the rear media pack installed but my question is do the seats have the required looms and plug breaks to be able to fit replacement headrests with the screens?
Regs Gavin

There’s no wiring at all for rear media. I say non but there is a pos wire from the CJB to the connector in the centre console.

You’re best bet is to buy a complete set up from a breaker as it’s a big job to create the looms from scratch. Also you need the 2012 setup rather than the earlier one.

A complete set up would require the RSE module, 2 headrests and screens, the wild fire sensor and rear alarm sensor unit, 2 or 3 wildfire headphones, the rear centre arm rear with remote and loom, the RSE loom and the 2 seat looms. There’s also quite a few CCF edits to carry out to.

If you do fit RSE you could also fit Dual View screen so your front passenger can share the joy. 2012 5.0 SC AB
Mods:
TPMS
Genuine LR DRLs
Remote Boot close from key fob
2016 Discovery 4 Mirrors AKA RRS2
2014 L405 Surround Camera retro fit (WIP)
2013 RRS Dual View Screen fit (Complete)
2016 LR4 RSE
2014 LR4 Homelink
2016 FFRR Electrochromatic Wing Mirror Glass

70 plate Focus ST (Current)
1942 VEP Ford GPW Jeep (Willys) (Current)
1943 Whites M16 Halftrack (Current)
16 plate Eurofighter Typhoon, 2 x Eurojet engines with 20,000lbs thrust each. 1380mph

Thanks for all the info! Think I’ll use tablets and holders rather than mess around with all that. Thanks once again.
Gav