Hi all,

I may be going crazy, but I cannot figure out where the rubber rear arch protectors mount.

None were present on my MY2010 when I bought it so I fitted the fronts, but on the rear, the plastic wheel arch liner is below the metal of the arch - is this correct or should it be above? (And then the rubber trim fits over the metal?)

Thanks in advance!

Last edited by knwatkins on Mon Oct 29 2018 6:20pm. Edited 1 time in total

Also if anyone could take a picture of theirs it would be much appreciated.

Sounds to me like liners are not fitted correctly, should be above metal wheel arch, then rubber fits over metal edge same as fronts.


Cheers
Col

Thanks Col. So the plastic arch liners should be above the metal, then the rubber clips onto the metal?

I did force the arch liner above the metal but I couldn't get the rubber protector on - too bloody tight.

That's how they go, not sure why pictures upside down, could be something to do with my current location in the world.

Click image to enlarge

Brilliant, cheers mate.

There’s a problem with Cols photo. Not enough mud in that arch. 2019 5.0 SC SVA (Current)
2012 5.0 SC AB. Sadly written off by a campervan
23 plate Focus ST (Current)
1942 VEP Ford GPW Jeep (Willys) (Current)
1943 Whites M16 Halftrack (Current)
16 plate Eurofighter Typhoon, 2 x Eurojet engines with 20,000lbs thrust each. 1380mph