Hi, I need to replace a broken fog light on my 2008 rrs HST. Do you have to completely remove the frot bumper to do this? Took the bezel off from the fog light but there is no securing screws showing.

Hi Jampot,

Not to sure but I did pop my bumper forward at the weekend to replace a parking sensor and it wasn't too difficult, seems
a little extreme though! about x6 8mm bolts x2 2 screws.
There is some access to the back of the bumper if you remove the front grill and headlamp? Regards,

Danny

Jampot1979 wrote:

Hi, I need to replace a broken fog light on my 2008 rrs HST. Do you have to completely remove the frot bumper to do this? Took the bezel off from the fog light but there is no securing screws showing.

Cheers for the reply. I will see what i can do at the weekend.

No worries Its not as bad as I had thought
I had hoped not to remove my bumper for the parking sensor replacement but when it didn't work I ended having to fault find the loom to find the broken wire! 10 minute job became 3 hrs!
If you can't get your arm in through the access from the headlamp removal there are 6 8mm bolts along the leading edge of the bumper, and 2 screws in the wheel arch, you can then ease/tip the bumper forward. * prior to when you ease the bumper forward put some tape on the front edge of the wings* This should prevent any rubbing from the bumper. Regards,

Danny